One of the most important resources for determining which plastic should be used in a chemical environment is a chemical resistance chart for plastics. These charts show how compatible different plastics are with a variety of chemicals and other fluids that fall on all points of the pH scale, from milk to mineral oil to fruit juice. Polycarbonate’s strongest appeal is its extreme durability. Not only is it shatterproof, but polycarbonate panels are virtually unbreakable. Compared to glass, polycarbonate sheets are 200 times stronger- and over ten times stronger than an acrylic sheet of the same size. This is why polycarbonate is often used for environments where intense Polymethyl methacrylate (PMMA) is also known as acrylic, acrylic glass, and by the trade names and brands Crylux, Plexiglas, Acrylite, Perclax, Astariglas, Lucite, and Perspex, among others. Polymethyl methacrylate (PMMA) is often used in sheet form as a lightweight or shatter-resistant alternative to glass. PMMA can also be used as a casting TruLife® Acrylic. TruLife® Acrylic is an innovative single sided, anti-reflective, abrasion resistant acrylic, developed specifically for direct print and face mount applications. It captures details with lifelike colors, incredible depth, and clarity for the highest-resolution viewing experience possible. 99% UV Protection. UV- and fade-resistant; perfect for homes that get a lot of sun; The highest quality latex paint labels feature the words “all acrylic” or “100 percent acrylic.” While cheaper paints Provides increased resistance to degradation of UV exposure, while transmitting increased UV suitable for suntan beds. Ultraviolet Filtering Sheet—UF-96, UF-3 and UF-4 Provides increased protection from ultraviolet wavelengths. UF-96 and UF-3 block all UV light below 395 nanometers. UF-4 blocks all UV light below 385 nanometers. UVF non glare acrylic sheets offer stunning museum-quality clarity with UV protection for glazing and fine artwork framing while remaining lightweight and impact resistant. These museum-quality UV acrylic sheets are many times more impact resistant, easier to handle, and more cost-effective to ship versus glass. PP has a lower density than HDPE and is therefore best used for lower weight molded parts. Its melting point ranges from 266 degrees F to 340 degrees F. Both PP and HDPE provide good chemical resistance and UV resistance; however, PP requires stabilization via additives, so HDPE may be preferred in many applications where UV resistance is a Bahhv.

is all plexiglass uv resistant